Steelcraft-automotive 31140 TAILLIGHT GUARD Bedienungsanleitung PDF herunterladen

INSTALLATION INSTRUCTIONS

TAILLIGHT GUARD PART#

02-05 FORD EXPLORER

Step One: Locate hardware and check contents with hardware listed below.

DESCRIPTION QTY

Taillight Guards (Left & Right) 2

Support Brackets 2

M4 x 16mm Phillips Machine Screws 2

M4 Flat Washers 2

Step Two: Remove factory screws that support the taillight to the vehicle (Figure 1). Carefully unfasten clips and

remove taillight. NOTE: Save screws for later use.

Step Three: Engage Support Bracket and hold it in place, as shown in Figure 2. While holding Support

Bracket, carefully re-install taillight and fasten factory clips (Figure 3).

Step Four: Locate (1) – M4 x 16mm Phillips Screw and (1) – M4 Flat Washer. Position Taillight Guard onto vehicle

and loosely attach Taillight Guard to Support Bracket by using the hardware listed in this step (Figure 4).

Step Five: Align Mounting Brackets to factory mounting holes. Use factory screws removed in step one to attach

Mounting Brackets to the vehicle (Figure 5). NOTE: Open and close rear door/lift slowly, to be certain that the

Taillight Guard does not interfere with rear door. Tighten all hardware at this time.

Repeat steps 2-5 for opposite side

Figure 1 Figure 2 Figure 3 Figure 4 Figure 5

Factory

Screws

Support

Bracket

Keine Kommentare

Steelcraft-automotive 31140 TAILLIGHT GUARD Bedienungsanleitung