Steelcraft-automotive 82120 REAR BUMPER GUARD Bedienungsanleitung PDF herunterladen

DOUBLE TUBE REAR BUMPER GUARD

11-13 JEEP GRAND CHEROKEE

11-13 DODGE DURANGO

Page 1 of 2 3/21/11 (DP)

PARTS LIST:

PROCEDURE:

REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS

RECOMMENDED. MAY INTERFERE WITH BACKUP SENSOR OPERATION.

1. Starting on the driver side of the vehicle, locate the (2) threaded holes in the left side upper

frame rail, (Figure 1). NOTE: These holes will be filled with hex bolts from the factory-remove

hex bolts. Select (1) Frame Mounting Bracket. Bolt the Mounting Bracket to the frame rail with

the factory 14mm hex bolts, (Figure 2). Do not tighten hardware at this time. Repeat this step

to install the Mounting Bracket on the passenger side. NOTE: It may be necessary to remove

excess sealant from the body seam to provide additional clearance for the Mounting Bracket,

(Figure 1).

2. Carefully position the Rear Bumper Guard up to the inside of the Mounting Brackets. Bolt the

Rear Bumper Guard to the Brackets using the included (4) 12mm x 35mm Hex Bolts, (8)

12mm Flat Washers, (4) 12mm Lock Washers and (4) 12mm Hex Nuts, (Figure 3). Do not

tighten hardware at this time.

3. Align Rear Bumper Guard and tighten all hardware.

4. Do periodic inspections of the installation to make sure that all hardware is secure and tight.

Rear Bumper Guard

Frame Mounting Brackets

12-1.75mm x 35mm Hex Bolts

12mm x 24mm OD x 2.5mm Flat Washers

12mm Lock Washers

12mm Hex Nuts

WARNING: ALLOW TIME FOR THE MUFFLER TO COOL COMPLETELY BEFORE

INSTALLING REAR BUMPER GUARD BRACKETS.

(2) Frame Mounting

Brackets

Complete Installation

1 2

DOUBLE TUBE REAR BUMPER GUARD 11-13 JEEP GRAND CHEROKEE 11-13 DODGE DURANGO Page 1 of 2 3/21/11

Seite 2

DOUBLE TUBE REAR BUMPER GUARD 11-13 JEEP GRAND CHEROKEE 11-13 DODGE DURANGO Page 2 of 2 3/21/11

Keine Kommentare

Steelcraft-automotive 82120 REAR BUMPER GUARD Bedienungsanleitung